Component-Level Repair Lab

Expert Micro-Soldering & Logic Board Repair

We repair the motherboards and logic boards that others refuse. Power rail analysis, microcontroller replacement, pad reconstruction, SMC and power management IC repair — for Mac, MacBook Air, MacBook Pro, gaming laptops and PCs, with nationwide mail-in service.

The Art of Component-Level Repair

Most repair shops and manufacturer "Genius" bars lack the equipment and expertise to perform micro-soldering. When they encounter a board failure, they suggest a full motherboard replacement—costing you thousands and wiping your data. We operate differently.

  • Micro-Soldering Mastery: We replace individual chips, capacitors, and resistors smaller than a grain of rice.
  • Data Protection: By repairing the original logic board, we preserve your T2 security pairing and your data.
  • Circuit Restoration: We jump broken traces and rebuild pads damaged by liquid corrosion or impact.
  • Nationwide Mail-In Repair: Not in South Florida? Ship your board or device to our lab from anywhere in the USA.

Power Rail Analysis & Repair

Every logic board runs on a network of voltage rails. When one rail collapses, the whole board goes dark. We systematically trace every rail — from the primary power input down to the sub-1V core rails that feed the CPU and GPU — to isolate shorts, open traces, and failed regulators.

DC-IN / PPBUS PP3V3 PP5V PP1V8 / PP1V2 VCORE / VCCGT
  • PPBUS_G3H & DC-IN: Verifying the main power path from the charger through the ISL9240/ISL95521 buck-boost controller.
  • 3.3V / 5V / 1.8V rails: Testing with a multimeter and oscilloscope for correct voltage, ripple, and sequencing.
  • VCORE / VCCGT / VCCSA: CPU and GPU core rail integrity — the most common source of "no power" and "no display".
  • Short hunting: Voltage injection with thermal camera and freeze spray to locate shorted capacitors, MOSFETs, and BGA components.
  • Rail sequencing: Confirming that each rail comes up in the correct order and timing (PGOOD, SLP_S3, SLP_S5 signals).

Voltage Injection

Controlled current injection into a suspect rail while monitoring thermal signatures to pinpoint shorted components without damaging good silicon.

Oscilloscope Verification

Checking rail ripple, startup timing, and PGOOD transitions — not just presence of voltage — to catch marginal regulators.

Microcontroller & SMC Repair

The System Management Controller (SMC) on Macs and the embedded controller (EC) on PCs are the "nervous system" of the board. They control power sequencing, battery charging, thermal management, fans, and keyboard backlight. A failed SMC/EC produces some of the most confusing symptoms: no charging, fans full-blast, no backlight, or a board that powers on but never boots.

  • SMC reball & replacement: BGA rework on the SMC chip (e.g., SMC 20-pin, T2-related management) with proper stencil, paste, and reflow profile.
  • EC firmware & BIOS: Reflashing corrupted embedded controller firmware and SPI BIOS chips (Winbond, Macronix, ISSI).
  • Microcontroller logic tracing: Verifying SMBus/I2C communication, clock lines, and reset signals between the SMC/EC and the PCH.
  • Pad & trace repair: Rebuilding lifted BGA pads under SMC/EC packages using copper foil and UV solder mask.
  • Keyboard & fan control: Fixing SMC-related keyboard backlight, fan curve, and battery charge issues.

Pad Reconstruction & Trace Repair

Liquid corrosion and heat damage lift pads off the PCB. A missing pad means a broken connection — and a board that won't power on or won't charge. We rebuild pads and traces to factory tolerance so components can be re-soldered reliably.

Lifted Pad Repair

  • Copper foil pad replacement
  • UV solder mask curing
  • Microscope alignment (<0.1 mm)
  • BGA and QFN pad rebuild

Broken Trace Jumping

  • Micro-jumper wire (0.02 mm)
  • Pad-to-pad trace restoration
  • Via repair and plating
  • Continuity verification

Corrosion Treatment

  • Ultrasonic cleaning
  • Electrolytic corrosion neutralization
  • Conformal coating touch-up
  • Full board inspection

Solder Joint Rework

  • Cold joint reflow
  • BGA reballing
  • QFN / DFN reattachment
  • Connector re-soldering

Power Management IC (PMIC) Repair

The PMIC is the board's power distribution hub. It converts battery and adapter voltage into the many regulated rails the CPU, GPU, memory, and peripherals need. A failed PMIC or its surrounding MOSFETs is one of the top causes of "dead" boards — and one of the most commonly misdiagnosed.

  • PMIC replacement: BGA rework on PMICs (e.g., MAX, ISL, TPS series) with proper thermal profiles.
  • Buck/boost converter repair: Replacing shorted MOSFETs, inductors, and feedback resistors in the VRM stages.
  • Charging circuit repair: Diagnosing and fixing ISL9240, ISL95521, BQ series charger ICs and the battery sense lines.
  • VRM phase analysis: Checking multiphase VRM operation for uneven load, dead phases, and thermal runaway.
  • Power sequencing faults: Tracing PGOOD, EN, and PG signals that prevent the board from completing its power-on sequence.
Repair Type Typical Cost Turnaround
MacBook Air / Pro Logic Board (power rail / PMIC) $225 – $525 2–4 Days
PC / Gaming Laptop Motherboard (VRM / charging circuit) $225 – $440 1–3 Days
SMC / EC / BIOS chip replacement $175 – $375 2–3 Days
Pad reconstruction & trace repair $150 – $350 2–4 Days
Gaming GPU / VRM rework $275 – $495 3–5 Days

Liquid Damage & Corrosion Triage

Spilled water, coffee, or wine? Time is your enemy. Liquid triggers immediate short circuits followed by rapid oxidation. Our lab provides professional ultrasonic cleaning and component-level triage.

Ultrasonic Cleaning

Removing hidden corrosion from under BGA chips using medical-grade cleaning solution.

Power Rail Analysis

Systematic tracing of 3.3V, 5V, and PPBUS_G3H rails to locate shorted components.

Corrosion Mapping

Microscope inspection of every pad, via, and trace under the damaged area before re-powering.

Re-coating & Protection

Conformal coating restoration to prevent future corrosion in treated areas.

Gaming Laptops, MacBooks & PC Motherboards

Gaming laptops like MSI, ASUS ROG, Alienware, Acer Predator, Lenovo Legion and HP OMEN push hardware to the limit. We specialize in repairing blown VRMs, shorted GPUs, and corrupted BIOS chips that cause "No Power" or "No Display" issues. We also service Mac, MacBook Air, MacBook Pro, iMac, and Windows desktops.

Mac / MacBook Air / Pro

Logic board repair, T2 pairing preservation, liquid damage, backlight, and charging circuit repair.

Gaming Laptops

VRM, GPU, BIOS, and power rail repair for MSI, ASUS ROG, Alienware, Predator, Legion, and OMEN.

Windows PCs & Desktops

Motherboard, power delivery, BIOS, and chipset-level repair for Dell, HP, Lenovo, ASUS, and custom builds.

Nationwide Mail-In

Anywhere in the USA — ship your board or device to our lab for the same component-level repair.

Board dead? Don't replace it — repair it.

Free diagnostics. No fix, no fee. Call now or book online — we'll pick up your device or arrange mail-in.

Call Text Quote WhatsApp